Product ID:PRIMER-WASH PRETREAT FORM 117 ID 728014
MSDS Date:10/14/1988
FSC:8010
NIIN:00-165-8577
MSDS Number: BHCYS

PRATT & LAMBERT, INC.

16116 E 13TH ST
WICHITA, KS 67201
US

Emergency Phone: 316-733-1361

Info Phone: 316-733-1361

Preparer: W.A. ELLISON

Cage: FO127

PRATT AND LAMBERT INC

22 CLEVELAND, OH 44101-1027 US

Telephone: 216-566-2902

Cage: 61196

ZINC CHROMATE

CAS: 13530-65-9

RTECS: GB3290000

OSHA PEL 0.1 MG/M3 (CRO3)

ACGIH TLV: 0.01MG/M3(CR)A1;9192

ISOPROPYL ALCOHOL (SARA III)

CAS: 67-63-0

RTECS: NT8050000

OSHA PEL 400 PPM/500 STEL

ACGIH TLV: 400 PPM/500STEL;9192

N-BUTYL ALCOHOL (SARA III)

CAS: 71-36-3

RTECS: EO1400000

OSHA PEL 100 PPM

ACGIH TLV: S, C 50 PPM; 9293

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

PHOSPHORIC ACID

CAS: 664-38-2

OSHA PEL 1 MG/CU.M

ACGIH TLV: 1 MG/CU.M

VOC. ORGANIC CMPD 5.9 LB/GL LESS WATER & NPRS* 708 G/L LESS

RTECS: 9999999VO

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:SWALL: MAY CAUSE SEVERE BURNS OF
MOUTH, ESOPHAGUS, STOMACH PAIN, NAUSEA & VOMITING. ASPIRATION OF
MATERIAL MAY CAUSE CHEM PHEUMONITIS. INHAL: SERVERE IRR UPPER
RESPIRATORY COUGH, BURNING OF THROAT, CH OKING SENSATION. DEEP
INHALATION MAY CAUSE PULMONARY EDEMA.EYE CORNEA DAMAGE SKIN:LIQ MAT
MAYBE ABSORBED SEVERE BURNIN
Explanation of Carcinogenicity:ZINC CHROMATE LISTED AS POTENTIAL
CARCINOGEN
Effects of Overexposure:SWALL:MAY CAUSE SEVERE BURNS OF MOUTH,
ESOPHAGUS,STOMACH PAIN, NAUSEA & VOMITING.ASPIRATION OF MATERIAL
MAYCAUSE CHEM PNEUMONITIS. INHAL:SEVERE IRR UPPER RESPIRATORY
COUGH, BURNING OF THROAT,CHOKING S ENSATION.DEEP INHALATION MAY
CAUS PULMONARY EDEMA.EYE CORNEA DAMAGE SKIN: SEVERE BURNING

First Aid:SWALL: DONOT INDUCE VOMITI GIVE 1OR2 GLASSES WATER TO DILUTE.
NEVER GIVE ANYTHING BY MOUTH TO UNCONSCIOUS PERSON. INHAL:REMOVE TO
FRESH AIR, BREATHING STOPPED GIVE CPR. KEEP WARM AND QUIET. OBTAIN
MED ATTENTION. EYE: FLUSH W/LG AMTS OF WTR.LIFTING EYELIDS FOR 15
MIN. GET MEDICAL ATTN. SKIN: FLUSH THE CONTAMINATED AREA W/LG AMTS
WTR. REMOVE CONTAMINATED CLOTHING.

Flash Point:53F/11.67C
Extinguishing Media:CLASS B FIRE EXTINGUISHERS DESIGNED TO EXTINGUISH
FLAMMABLE LIQUID FIRES. POLYMER FOAM IS PREFERRED FOR LARGE FIRES.
Fire Fighting Procedures:WEAR SELF CONTAINED BREATHING APPARATUS. WATER
MAY BE INNEFECTIVE, BUT MAY BE USED TO PREVENT PRESSURE BUILD-UP.
IF WATER IS USED, FOG NOZZLES ARE PREFERABLE.
Unusual Fire/Explosion Hazard:DURING EMERGENCY CONDITIONS, OVEREXPOSURE
TO DECOMPOSITION PRODUCTS MAY CAUSE A HEALTH HAZARD. OBTAIN MEDICAL
ATTENTION. WARNING! FLAMMABLE.

Spill Release Procedures:WEAR APPROPRIATE PROTECTIVE EQUIP.
RESPIRATORS,EYEPROTECTION, ACID IMPERVIOUS GLOVES AND BODY
SUITS,VENTILATE AREA OF LEAK. STOP SOURCE OF LEAK. KEEP SPECTATORS
AWAY. ELIMINATE ALL SOURCES OF IGNITION . DIKE AND CONTAIN SPILL
W/INERT MATERIAL.

Handling and Storage Precautions:DO NOT STORE ABOVE 95F. STORE LARGE
QUANTITIES IN COMPLIANCE WITH OSHA 29CFR1910.106. DO
NOT TAKE INTERNALLY. CLOSE CONTAINER AFTER USE.
Other Precautions:EMPTY CONTAINERS MUST NOT BE WASHED AND RE-USED FOR
ANY PURPOSE. CONTAINERS SHOULD BE GROUNDED AND BONDED TO THE
RECEIVING CONTAINER. DO NOT WELD, BRAZE OR CUT ON EMPTY CONTAINERS.
NEVER USE PRESSURE TO EMPTY. DRUM IS NOT A PRESSURE VESSEL.

Respiratory Protection:NOT REQD IN WELL VENTILATED AREAS. RESTRICTED
AREAS A NIOSH APPROVED CHEMICAL CARTRIDGE RESPIRATOR MAYBE REQD.
UNDER CERTAIN COND (SPRAYING) MECHANICAL PREFILTER MAY BE REQD.
Ventilation:PROVIDE GENERAL DILUTION AND LOCAL EXHAUST VENTILATION IN
SUFFICIENT VOLUME AND PATTERN TO MAINTAIN CONCENTRATIONS.
Protective Gloves:SOLVENT IMPERMEABLE GLOVES
Eye Protection:WEAR SAFETY SPECTACLES-CHEMICAL SPLASH
Other Protective Equipment:NOT LIKELY NEEDED
Supplemental Safety and Health
NK

Boiling Pt:B.P. Text:180-500F
Vapor Density:>THAN AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:90

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALINE MATERIALS
Stability Condition to Avoid:AVOID EXCESSIVE HEAT AND SOURCES OF
IGNITION.
Hazardous Decomposition Products:BURNING,INCLUDING WHEN HEATED BY
WELDING OR CUTTING, WILL PRODUCE SMOKE,CARBON MONOXIDE & CARBON
DIOXIDE.OXIDES CHROMIUM
Conditions to Avoid Polymerization:KEEP AWAY FROM HEAT SPARKS AND
FLAME.

Waste Disposal Methods:DISPOSE IAW FEDERAL, STATE AND LOCAL LAWS.
OBSERVEPRECAUTIONS FOR DISPOSAL OF FLAMMABLE MATERIAL. DO NOT
INCINERATE IN CLOSED CONTAINERS. PROPER RCRA
CLASSIFICATION WOULD BE D001.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.